I did a full wrap engrave on a 20 oz tumbler today. I used the chuck and my RA2 pro. The file is from ETSY. It took 2.5 hrs to complete but I’m going to try different settings to have it finish faster. The tumbler was purchased from Amazon.
Basic Information is loading...
Step 1
Setting 1
Process Method
Vector Laser Engrave
Power(%) or Cut Pressure(g)
50
Speed(mm/s)
80
Lines per cm
140
Pass
1
Bitmap mode
Grayscale
Other Parameters
Note I had to fill in the boxes above but I did a vector engrave from a svg so there was no bitmap mode needed.
I purchased the file from ETSY. I did a lot of testing on a practice tumbler to dial in my settings. I plan to do more tumblers! See my photos for settings and how I set up my image on the screen.
I purchased the file from ETSY. I did a lot of testing on a practice tumbler to dial in my settings. I plan to do more tumblers! See my photos for settings and how I set up my image on the screen.