mageN
I have a very special mum friend who adores Turtles. I wanted to make her something special for always supporting me.
Step 1
Have a traced image of the turtle ready to go (Lightburn: right click on image to trace it.)
When happy with the image put in on the engrave setting mine was 150spd 20%.
I then placed a 5mm circle where I wanted the ornament to hang from then created an offset line around the circle and the turtle (about 5mm).
The offset line and circle I put on CUT setting 100% 5spd
Step 2
Once cut and engraved just thread a piece of string through the hole and the decorations are complete.
this process can be used with any number of images to create a multitude of decorations.
Step 1
Have a traced image of the turtle ready to go (Lightburn: right click on image to trace it.)
When happy with the image put in on the engrave setting mine was 150spd 20%.
I then placed a 5mm circle where I wanted the ornament to hang from then created an offset line around the circle and the turtle (about 5mm).
The offset line and circle I put on CUT setting 100% 5spd
Step 2
Once cut and engraved just thread a piece of string through the hole and the decorations are complete.
this process can be used with any number of images to create a multitude of decorations.