DesignFind

Add png file to engraving on cutting board.

I can engrave direct with this png but I want to use the svg engraving.

So I add the outline with 0 measure.

And then I engraved to a cutting board

Clean the engraved board with water and let it dry.

Put some drops on the cutting board.

Just wipe it on, let it soak in for about 10-20 minutes, then wipe it off with a clean rag.

and let it dry by sun

Add the design file to XCS

and resize it to fit on apron.

change the laser flat to blade cut.

flip the design file for iron-on vinyl.

Add the xtool heat transfer vinyl into M1.

Use the cutting mat.

and then cut it with the

Peel off all unnecessary parts from the vinyl.

Apply the vinyl to apron by IRON

stick the peeled vinyl on the apron and cover the teflon sheet to the vinyl.

Press the iron onto the Teflon sheet and move slowly for 45 seconds.

wait until the vinyl was cold.

And then peel the plastic sheet slowly.

And cover the Teflon sheet again.

Press again the iron for 30 seconds.

all is done, Your apron was ready to use.

ready to give now.

Thank you for watching my projects.