I saw this project shared by @metoudesign on the home page recommendation and thought this is really cute and easy to make. It only took me less than 5 mins to make it.
Basic Information is loading...
Step 1: Cut the ornament shape
Setting 1
Process Method
Vector Laser Engrave
Power(%) or Cut Pressure(g)
15
Speed(mm/s)
250
Lines per cm
100
Pass
1
Setting 2
Process Method
Laser Cut
Power(%) or Cut Pressure(g)
90
Speed(mm/s)
35
Pass
1
Cut the ornmanet using your machines. The new “easyset” function of XCS 2.0 allows you to choose the ideal effect based on your machines, so you don't have to use a P2 to make this project. Just use your machine and adjust the settings using the “easyset” function.
Step 2: Cut the middle layer using a colored paper
I just used the bottom part to make a outline on a wrapping paper, then cut it out.
Tip: I think it would be better to cut within the outline because when I glue them I found the middle layer is a bit bigger than I expected.
Step 3: Glue the layers together
This is probably the most important part
Tip: Remember to glue the mirror opposite side cause I got it wrong the first time so I wash the glue off and did it again
Cut the ornmanet using your machines. The new “easyset” function of XCS 2.0 allows you to choose the ideal effect based on your machines, so you don't have to use a P2 to make this project. Just use your machine and adjust the settings using the “easyset” function.
I just used the bottom part to make a outline on a wrapping paper, then cut it out.
Tip: I think it would be better to cut within the outline because when I glue them I found the middle layer is a bit bigger than I expected.
This is probably the most important part
Tip: Remember to glue the mirror opposite side cause I got it wrong the first time so I wash the glue off and did it again
Simple and cute