This is a 2 sided pumpkin made from wood and cardstock.
One side has Halloween themed cardstock and the words Happy Halloween on engraved on the leaf.
Turn the pumpkin around, and the opposite side has orange cardstock. The leaf is turned backwards so the plain side is showing.
All total 4 layers of wood were used, helping it to stand by itself, though I'm considering making a stand for it to make it more stable.
Tip: If you hate the smell of stain like I do, use an old rag and watered down paint to wipe over wood and then wipe off after a few minutes with a dry rag. Result looks like the wood has been stained without the smell.
Making the pumpkin two sided allows it be left out past Halloween into fall.
Basic Information is loading...
Settings
Setting 1
Power(%) or Cut Pressure(g)
100
Speed(mm/s)
7
Lines per cm
100
Pass
1
Other Parameters
Engraved words on leaf using 3mm basswood preset in XCS
cardstock was also cut on the laser using the corrugated paper preset.
No data