Projects
Designs Forum Contests
Full wrap on kids Yeti tumbler
36
309
3
Design Files
  • IMG_5872.png
    • Contents
    Introduction
    Basic Information
    Settings
    Design Files
    I have only had my xtool M1 for about a week now and have already figured out how to do a full wrap engraving. First I measured the perimeter and height of my tumbler. Then I put it on the RA2Pro chuck and leveled the middle of it with the included bubble leveler. Lastly, I got my focal distance with the included ruler, framed it to make sure the design was where I wanted it, and pressed start.
    Basic Information is loading...
    Settings
    Setting 1
    Process Method
    Vector Laser Engrave
    Process Material
    Stainless Steel Tumbler kit with Handle Seafoam
    Power(%) or Cut Pressure(g)
    100
    Speed(mm/s)
    150
    Lines per cm
    140
    Pass
    1
    Bitmap mode
    Grayscale
    Design Files
    IMG_5872.png
    Yeti
    Fullwrap
    xtoolm1
    Engrave
    RA2Pro
    Do you like this template?
    Remixes (0)
    Add Remix
    There are no remixes yet.