Projects
Designs Forum Contests
Cork Coaster Laser Engraving
12
229
1
Design Files
  • cork - blaze logo.xcs
    F1
    • Contents
    Introduction
    Basic Information
    Settings
    Design Files
    This remix is based on
    3.95" Round Coaster Jig
    Jaccobb
    This is a quick and fun DIY I attempted and the finish product came out great! By the way a big thanks and a shoutout to @Jaccobb who hooked it up with the JIG to make this laser DIY a success!
    Basic Information is loading...
    Settings
    Setting 1
    Process Method
    Laser Cut
    Process Material
    3mm Basswood Plywood
    Power(%) or Cut Pressure(g)
    70
    Speed(mm/s)
    3
    Pass
    1
    Other Parameters
    The Engraving of font and logo parameters were Blue light 90, Speed 500, 1 Pass, 200 lines per cm.
    Setting 2
    Process Method
    Vector Laser Engrave
    Process Material
    Cork Coaster
    Power(%) or Cut Pressure(g)
    100
    Speed(mm/s)
    4000
    Lines per cm
    220
    Pass
    1
    Other Parameters
    This is all the parameters used, good luck!
    Design Files
    cork - blaze logo.xcs
    corkcoaster
    xtool
    cork
    coaster
    DIY
    F1
    settings
    Do you like this template?
    Remixes (0)
    Add Remix
    There are no remixes yet.