Projects
Designs Forum Contests
He Has Risen Earrings
1
53
1
Design Files
  • Nail Crosses on 2.5mm coaster board.xcs
    D1Pro
    • Contents
    Introduction
    Basic Information
    Settings
    Design Files
    This is the result of my wife wanting me to make her something special and unique for Easter. The crosses were an SVG and Font used was XCS Shirtliner.
    Basic Information is loading...
    Settings
    Setting 1
    Process Method
    Vector Laser Engrave
    Process Material
    2.5mm Coaster Blanks
    Power(%) or Cut Pressure(g)
    70
    Speed(mm/s)
    80
    Lines per cm
    100
    Pass
    1
    Bitmap mode
    Grayscale
    Other Parameters
    These where the optimal settings for my machine after running test grids
    Setting 2
    Process Method
    Bitmap Laser Engrave
    Process Material
    2.5mm Coaster Blanks
    Power(%) or Cut Pressure(g)
    70
    Speed(mm/s)
    80
    Lines per cm
    100
    Pass
    1
    Other Parameters
    For this setting there was no Bitmap mode due to the text being done with XCS and again used the optimal settings for my machine
    Setting 3
    Process Method
    Laser Cut
    Process Material
    2.5mm Coaster Blanks
    Power(%) or Cut Pressure(g)
    100
    Speed(mm/s)
    3
    Pass
    2
    Other Parameters
    This settings worked best for me, found them on X-tools material setting page.
    Design Files
    Nail Crosses on 2.5mm coaster board.xcs
    BeIn30Creators
    Do you like this template?
    Remixes (0)
    Add Remix
    There are no remixes yet.